36V DPOT

A resource for technical documentation. Datasheets, application notes, instruction manuals, books and links to resources are found in the Document Library.
Post Reply
User avatar
JR.
Posts: 2694
Joined: Sat May 24, 2008 7:21 pm

36V DPOT

Post by JR. » Tue Feb 26, 2019 11:54 am

http://ww1.microchip.com/downloads/en/D ... 05304A.pdf

Last time I designed with DPOT they did not have 36V capability.

50 pages of data but no linearity curves.

JR

User avatar
mediatechnology
Posts: 3676
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: 36V DPOT

Post by mediatechnology » Tue Feb 26, 2019 12:24 pm

Nice part if it's clean.

I suppose we need to buy an evaluation board and test it.
https://ka-electronics.com

SOCIAL MEDIA PLATFORMS should advance FREEDOM OF SPEECH. Yet too many Americans have seen their accounts suspended, banned, or fraudulently reported for unclear “violations” of user policies. No matter your views, if you suspect political bias caused such an action to be taken against you, share your story with President Trump.
White House Tech Censorship Reporting Link: https://whitehouse.typeform.com/to/Jti9QH
The Most Banned Network In The World: https://www.infowars.com/show
BANNED VIDEO - UK Police Escort A Muslim Mob To ATTACK Tommy Robinson:https://www.newswars.com/censored-video ... n-england/

lsburden
Posts: 9
Joined: Tue Oct 23, 2018 2:24 pm
Location: Wimberley, TX

Re: 36V DPOT

Post by lsburden » Fri Mar 01, 2019 12:55 pm

Look at section 5.1.2 Step Resistance. There may not be any linearity curves but there are step resistance specs.

I have been looking at the AD5292. I was hoping to use them as I would a mechanical pot but so far am not happy with the distortion. I have also considered the MCP45HVX1 but I doubt its distortion would be any better, the AD5292 touts low distortion...
Unless I am doing something wrong I am not looking to use digi-pots directly in an audio path.

On a side note, I have used the THAT5171 and 5173 with phenomenal results. My initial expectations with digi-pots were based on experience with the THAT devices. Needless to say I was very disappointed.

User avatar
mediatechnology
Posts: 3676
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: 36V DPOT

Post by mediatechnology » Fri Mar 01, 2019 1:37 pm

lsburden wrote:
Fri Mar 01, 2019 12:55 pm
On a side note, I have used the THAT5171 and 5173 with phenomenal results.
I have too. Somewhere I have a schematic of a simple U-pad attenuator I made with a 5173 and its distortion was at my residual levels.

This is the Universal Input I made with one where the 517X works as a pad ahead of the mic preamp and then gets flipped to make it switch from attenuation to gain fluidly. viewtopic.php?f=6&t=514

Image
A Universal Input Using the THAT1570 and 5173.
https://ka-electronics.com

SOCIAL MEDIA PLATFORMS should advance FREEDOM OF SPEECH. Yet too many Americans have seen their accounts suspended, banned, or fraudulently reported for unclear “violations” of user policies. No matter your views, if you suspect political bias caused such an action to be taken against you, share your story with President Trump.
White House Tech Censorship Reporting Link: https://whitehouse.typeform.com/to/Jti9QH
The Most Banned Network In The World: https://www.infowars.com/show
BANNED VIDEO - UK Police Escort A Muslim Mob To ATTACK Tommy Robinson:https://www.newswars.com/censored-video ... n-england/

lsburden
Posts: 9
Joined: Tue Oct 23, 2018 2:24 pm
Location: Wimberley, TX

Re: 36V DPOT

Post by lsburden » Fri Mar 01, 2019 2:37 pm

that's pretty slick

Post Reply