Power Supply Filter Calculations

Where we discuss new analog design ideas for Pro Audio and modern spins on vintage ones.
Post Reply
User avatar
mediatechnology
Posts: 3799
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Power Supply Filter Calculations

Post by mediatechnology » Sun May 25, 2008 11:28 pm

We often get the question "how large of a filter cap do I need?"

Here's a way to calculate it:

Image

The load resistance term, Rl, can be estimated from the average voltage (at a hypothetical regulator input) divided by the maximum expected current. Fr is the ripple frequency. Using full-wave rectification Fr would be either 100 or 120 Hz. As a practical matter, use 100 Hz.

The full text where I obtained the equation is from Hemes:

https://www.ka-electronics.com/images/p ... _Temes.pdf

And the National Semiconductor Audio Handbook:

https://www.ka-electronics.com/images/p ... Design.pdf

Construction information for the Pico PSU board using the LM317/LM337 is here:

https://www.ka-electronics.com/PicoComp ... uments.htm
https://ka-electronics.com

The United Nations Agendas: A Totalitarian Map: https://www.zerohedge.com/news/2019-07- ... tarian-map
Facebook Sanctions Violent Threats Against ‘Dangerous Individuals’: https://www.breitbart.com/tech/2019/07/ ... dividuals/
The Most Banned Network In The World: https://www.infowars.com/show

Post Reply