Zener voltage is 2.7v
The detector is a part of this compressors character so I think I will stay as close as possible.
The original designs combines the compressor and limiter CV's with parallelled transistors.
Thanx for the suggestions!
Summing Left & Right but lowering Center information
-
- Posts: 20
- Joined: Sat Oct 17, 2009 8:21 am
Re: Summing Left & Right but lowering Center information
Thomas TK Kristiansson
Sweden
Vintagedesign / TK Audio
Sweden
Vintagedesign / TK Audio
- mediatechnology
- Posts: 5466
- Joined: Sat Aug 11, 2007 2:34 pm
- Location: Oak Cliff, Texas
- Contact:
Re: Summing Left & Right but lowering Center information
Ancient thread but I recently became aware of the answer to the original question.
The Studer 90° Degree Filter
This is done by phase shifting L and R so that they are 90° apart.
L+R then becomes decorrelated.
Studer 90° Allpass FIlter Block Diagram
Studer 90° Allpass FIlters Schematic
Studer Stereo to Mono 90° Allpass Filter https://www.proaudiodesignforum.com/ima ... 14.533.pdf
The Studer 90° Degree Filter
In other words L+R for coherent signals results in a +3 dB increase instead of +6 dB.This active 90° filter is used to form a monophonic signal from the left and right channel of stereo signals. Simple mixing of the left and right channel will not produce a mono signal of satisfactory quality, but results in an emphasis of the center information. By summing the stereo signals in a 90° phase-shifted manner, this undesirable effect can be avoided.
This is done by phase shifting L and R so that they are 90° apart.
L+R then becomes decorrelated.
Studer 90° Allpass FIlter Block Diagram
The 90° filter consists of two all-pass filter chains, producing a uniform 90° phase difference across the whole audio range. The left and the right stereo signals are each passed through one of these filters and added at the filter’s output. Doubling of equally-phased signal components as well as canceling of opposite-phased components is thus avoided.
Studer 90° Allpass FIlters Schematic
Studer Stereo to Mono 90° Allpass Filter https://www.proaudiodesignforum.com/ima ... 14.533.pdf