36V DPOT

A resource for technical documentation. Datasheets, application notes, instruction manuals, books and links to resources are found in the Document Library.
Post Reply
User avatar
JR.
Posts: 2755
Joined: Sat May 24, 2008 7:21 pm
Contact:

36V DPOT

Post by JR. » Tue Feb 26, 2019 11:54 am

http://ww1.microchip.com/downloads/en/D ... 05304A.pdf

Last time I designed with DPOT they did not have 36V capability.

50 pages of data but no linearity curves.

JR
Visit https://circularscience.com to hear what properly "cleared" drums sound like.

User avatar
mediatechnology
Posts: 3721
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: 36V DPOT

Post by mediatechnology » Tue Feb 26, 2019 12:24 pm

Nice part if it's clean.

I suppose we need to buy an evaluation board and test it.
https://ka-electronics.com

Pinterest Bans Zero Hedge By Adding To "Porn Domain Block List" Used To Target Conservatives:https://www.zerohedge.com/news/2019-06- ... servatives
The Most Banned Network In The World: https://www.infowars.com/show
Google Can’t Dodge Conservative Employees’ Discrimination Lawsuit, Court Says: https://www.breitbart.com/tech/2019/06/ ... ourt-says/

lsburden
Posts: 19
Joined: Tue Oct 23, 2018 2:24 pm
Location: Wimberley, TX

Re: 36V DPOT

Post by lsburden » Fri Mar 01, 2019 12:55 pm

Look at section 5.1.2 Step Resistance. There may not be any linearity curves but there are step resistance specs.

I have been looking at the AD5292. I was hoping to use them as I would a mechanical pot but so far am not happy with the distortion. I have also considered the MCP45HVX1 but I doubt its distortion would be any better, the AD5292 touts low distortion...
Unless I am doing something wrong I am not looking to use digi-pots directly in an audio path.

On a side note, I have used the THAT5171 and 5173 with phenomenal results. My initial expectations with digi-pots were based on experience with the THAT devices. Needless to say I was very disappointed.

User avatar
mediatechnology
Posts: 3721
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: 36V DPOT

Post by mediatechnology » Fri Mar 01, 2019 1:37 pm

lsburden wrote:
Fri Mar 01, 2019 12:55 pm
On a side note, I have used the THAT5171 and 5173 with phenomenal results.
I have too. Somewhere I have a schematic of a simple U-pad attenuator I made with a 5173 and its distortion was at my residual levels.

This is the Universal Input I made with one where the 517X works as a pad ahead of the mic preamp and then gets flipped to make it switch from attenuation to gain fluidly. viewtopic.php?f=6&t=514

Image
A Universal Input Using the THAT1570 and 5173.
https://ka-electronics.com

Pinterest Bans Zero Hedge By Adding To "Porn Domain Block List" Used To Target Conservatives:https://www.zerohedge.com/news/2019-06- ... servatives
The Most Banned Network In The World: https://www.infowars.com/show
Google Can’t Dodge Conservative Employees’ Discrimination Lawsuit, Court Says: https://www.breitbart.com/tech/2019/06/ ... ourt-says/

lsburden
Posts: 19
Joined: Tue Oct 23, 2018 2:24 pm
Location: Wimberley, TX

Re: 36V DPOT

Post by lsburden » Fri Mar 01, 2019 2:37 pm

that's pretty slick

Post Reply