Mid Side M-S Matrix Uses No Precision Resistors

Where we discuss new analog design ideas for Pro Audio and modern spins on vintage ones.
Gold
Posts: 648
Joined: Sat Dec 01, 2007 6:20 pm

Re: Mid Side M-S Matrix Uses No Precision Resistors

Post by Gold » Wed Dec 15, 2021 7:35 pm

After thinking about it again I think the 8 pole 3 pos switch is the best answer. Signal Input goes to Wiper 1-4. Attenuator Input is from Wiper 5-8. In Position 1, Wiper 1-4 Signal input connects to Poles 1-4. Poles 1-4 are jumpered to Poles 5-8. Poles 5-8 feed Attenuator Input. In Position 2, Poles 1-4 feed M/S Input. Poles 5-8 see M Out to both channels. In Position 3, Poles 1-4 are M/S Input. Poles 5-8 are Side Out to both channels.

The only issue I can see is if using a shorting switch the M 1646 would short to the S 1646. Would that be a problem?

User avatar
mediatechnology
Posts: 5062
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: Mid Side M-S Matrix Uses No Precision Resistors

Post by mediatechnology » Thu Dec 16, 2021 4:51 am

The only issue I can see is if using a shorting switch the M 1646 would short to the S 1646. Would that be a problem?
Between positions? Probably not a problem.
https://ka-electronics.com

Apple-flavored Ivermectin is delicious.

Post Reply