Mid Side M-S Matrix Construction Information

Construction information for DIY projects, including the MS Mid Side Matrix, Elliptic Equalizer, Mastering Console, Phono Transfer System, Insert Switcher and the Dual Class-A Amplifier. You can post your baby pictures here.
User avatar
mediatechnology
Posts: 4599
Joined: Sat Aug 11, 2007 2:34 pm
Location: Oak Cliff, Texas
Contact:

Re: Mid Side M-S Matrix Construction Information

Post by mediatechnology » Sat Jan 16, 2021 7:07 pm

Wow, the jigs and results are impressive.

What is the wrench in the top right-hand corner of the first frame?
I have one of those in the garage that was my Dad's.

I have a letter and number punch set similar to yours that I inherited from either my Dad or brother.
https://ka-electronics.com

Plandemic Series: "Pland3mic - Indoctornation" https://proaudiodesignforum.com/content ... nation.mp4
Plandemic Series: "Plandemic - Doctors In Black" https://proaudiodesignforum.com/content/Plandemic.mp4

CDC: "For 6% of the deaths, COVID-19 was the only cause mentioned. For deaths with conditions or causes in addition to COVID-19, on average, there were 2.6 additional conditions or causes per death." https://www.cdc.gov/nchs/nvss/vsrr/covi ... /index.htm

Gold
Posts: 626
Joined: Sat Dec 01, 2007 6:20 pm

Re: Mid Side M-S Matrix Construction Information

Post by Gold » Sat Jan 16, 2021 7:28 pm

mediatechnology wrote:
Sat Jan 16, 2021 7:07 pm
What is the wrench in the top right-hand corner of the first frame?
I have one of those in the garage that was my Dad's.

I have a letter and number punch set similar to yours that I inherited from either my Dad or brother.
The wrench in the drawer is for a Foredom rotary tool. I think that particular wrench may be for an angle grinder attachment that I sold because I didn't use it.

I bought three letter and number sets. I have 1/4", 3/16" and 1/8". I also have some special characters in different sizes. The original plan was to do engraved faceplates. This was supposed to be a stopgap measure. I don't have the money, space, time or energy to do the engraved faceplates. Maybe in the future. I also realized I've spent a small fortune on this setup. The templates cost me a couple of thousand bucks to have made and the hand stamps were somewhere in that neighborhood as well. Not to mention the hundreds of hours I put in figuring out the technique.

Post Reply