Wow, the jigs and results are impressive.
What is the wrench in the top right-hand corner of the first frame?
I have one of those in the garage that was my Dad's.
I have a letter and number punch set similar to yours that I inherited from either my Dad or brother.
Mid Side M-S Matrix Construction Information
- mediatechnology
- Posts: 5472
- Joined: Sat Aug 11, 2007 2:34 pm
- Location: Oak Cliff, Texas
- Contact:
Re: Mid Side M-S Matrix Construction Information
The wrench in the drawer is for a Foredom rotary tool. I think that particular wrench may be for an angle grinder attachment that I sold because I didn't use it.mediatechnology wrote: ↑Sat Jan 16, 2021 6:07 pm What is the wrench in the top right-hand corner of the first frame?
I have one of those in the garage that was my Dad's.
I have a letter and number punch set similar to yours that I inherited from either my Dad or brother.
I bought three letter and number sets. I have 1/4", 3/16" and 1/8". I also have some special characters in different sizes. The original plan was to do engraved faceplates. This was supposed to be a stopgap measure. I don't have the money, space, time or energy to do the engraved faceplates. Maybe in the future. I also realized I've spent a small fortune on this setup. The templates cost me a couple of thousand bucks to have made and the hand stamps were somewhere in that neighborhood as well. Not to mention the hundreds of hours I put in figuring out the technique.